Consi Studio PCB-Mount Stabilizers V3 introduce a redesigned slider-crank mechanism that keeps the stabilizer wire controlled through the keystroke. Instead of the wire moving loosely inside the stem, the central slider rotates around a fixed pivot while the wire slides smoothly through the mechanism—reducing wire play, wobble, and rattle at the source.
V3 combines simple clip-in installation with a top-entry screw-expansion retention clip. Install the stabilizer as a clip-in unit, then tighten the support screw from above to expand the retention clip and secure the housing firmly to the PCB. No metal component contacts the PCB during installation.
Every unit is factory tuned and pre-lubed at its required contact points for a smooth, consistent keystroke out of the box. No additional tuning or lubrication is required for installation.
Set Configuration
1 + 1 + 4 set: four 2U stabilizers, one 6.25U stabilizer, and one 7U stabilizer. The 6.25U and 7U stabilizers are supplied as fully assembled, pre-lubed units.
Specs:
Mounting Style
PCB Mount
Mechanism
Slider-crank stabilizer mechanism
Retention System
Clip-in base with top-entry screw-expansion retention clip
Lubrication
Factory tuned and pre-lubed
Compatibility
Accessories included for different PCB thicknesses and layouts
All of my 2Us were perfect out of the box and usable. The 6.25U and 7U however, I could not get either one to work without ticking and rattling at all even after hours spent on trying to retune them as best as I can. Maybe for V4 the housing to stem tolerances can be a little tighter so the stem has a bit less play inside the housing, but that's my only real complaint. I will be sticking to knight V4s + stem spacers for my spacebar for now because those are still flawless, but will use ConSi moving forward for all 2U keys. They are as good as tuned Knight V4 assuming you get a good batch.
